本文已被:浏览 1534次 下载 0次
投稿时间:2015-10-19 修订日期:2016-09-19
投稿时间:2015-10-19 修订日期:2016-09-19
中文摘要: 为了优化磨矿操作,缓解锡石过磨和硫化矿欠磨的矛盾,本文研究了入磨粒度、磨矿时间及磨矿浓度三个因素对磨矿产物中各个粒级产率、金属分布率的影响规律。结果表明:入磨粒度对磨矿效果影响明显,比较-2 mm和-3 mm两个入磨粒度,-2 mm的磨矿效果较好;随着磨矿时间的增加,磨矿产物中不同金属锡、锌、铅、铁的分布率变化规律大致相似,即粗粒级中锡、锌、铅、铁的金属分布率减小,细粒级金属分布率增大;磨矿浓度从50%增大到75%时,磨矿效果逐渐改善,磨矿浓度超过75%后,磨矿效果变差。入磨粒度为-2 mm,磨矿时间为4~6 min,磨矿浓度为75%时,有效缓解了锡石过磨和硫化矿欠磨的矛盾,磨矿效果较好。
Abstract:In order to optimize the grinding operations and relieve the contradiction between over grinding of cassiterite and deficient grinding of sulphide ore, the influence of the parameters such as grinding feed size, grinding time and grinding concentration on the size fraction yield and the metal distribution were studied in this paper. The results show that the grinding feed size has important influence on grinding effect. Compared with -2 mm and -3 mm, -2 mm feed size is good to grinding. Different metal distribution variations is mainly similar following the grinding time. The metal distributions of Sn, Zn, Pb, Fe of coarse size fraction reduces and the metal distribution of small size fraction raises with increasing the grinding time. The grinding effect is gradually improved when the grinding concentration is varied from 50% to 75%. After 75%, the grinding effect will deteriorate. It is that the contradiction between the over grinding of cassiterite and the deficient grinding of sulphide ore is relieved effectively and the grinding effect is better than other conditions in the conditions of the grinding feed size -2 mm, the grinding time 4~6 min and the grinding concentration 75%.
keywords: Cassiterite polymetallic sulfide ore over grinding deficient grinding grinding feed size grinding time grinding concentration
文章编号: 中图分类号: 文献标志码:
基金项目:973计划前期研究专项,课题编号:2014CB460606;国家自然科学基金资助项目,课题编号:51264001。广西高校矿物工程重点实验室资助项目。广西生态型铝产业协同创新中心资助项目
引用文本:
杨金林,周文涛,马少健,杨晓静.锡石多金属硫化矿磨矿试验研究[J].有色金属(选矿部分),2017(1):60-64.
YANG Jinling,ZHOU Wentao,MA Shaojian,YANG Xiaojing.Experimental Study on Grinding of Cassiterite Polymetallic Sulfide Ore[J].Nonferrous Metals(Mineral Processing Section),2017(1):60-64.
杨金林,周文涛,马少健,杨晓静.锡石多金属硫化矿磨矿试验研究[J].有色金属(选矿部分),2017(1):60-64.
YANG Jinling,ZHOU Wentao,MA Shaojian,YANG Xiaojing.Experimental Study on Grinding of Cassiterite Polymetallic Sulfide Ore[J].Nonferrous Metals(Mineral Processing Section),2017(1):60-64.